I'm experiencing quite a bit of lag this morning.

The pages panel will expand all the pages you have clicked on the revision number (circled below) for the current session (i.e. until the tab is r...

Currently there seems to be a very minor bug that the 'Measurement Type' doesn't really change when the takeoff type changes. You get someth...

Below are a few hide/unhide functions that have been swimming around in my head since I started using zzTakeoff: Hide/unhide gray folders and...

I think Section Properties are zzTakeoff's answer to OST's Areas function. If so, there needs to be a way to be able to visualize which takeof...

I'm playing around with the new update this morning and really like where the new Section Properties feature is going. A couple suggested imp...

I have heavily adopted using the sum feature in a manual takeoff for takeoffs that should total up; and I have noticed that if you add a takeoff f...

I understand you can move takeoffs by holding down the 'Alt' key, but my perfectionism wants to move takeoffs by snap points to another snap point...

Anyone else having this issue? I've tried it on Chrome and Firefox.

I would like the ability to 'Covert To Similar' where if you select a takeoff and use the 'Convert to' function with an option toggled on that it ...

I think it would be nice to be able to select multiple takeoffs and update the measurement output/UofM. This would help with the batch insert and ...

I have 100+ takeoffs that I created through the 'Batch Insert Takeoff' tool and the measurement 1 output is area. I would like them to be section ...

Formula in the vertical linear cell: sum('Vertical Linear:FT')+sum('Linear:FT') I'm not a mathematician, but 9 + 10 =/= 19.79.

Can I use it to sum assembly type takeoff quantities to another assembly per screenshot below?

Now I have to hit enter then n. Side note- I appreciate the update to the 'n' hotkey.

Say zzTO didn't match A101 to A201 because the page number changed but that wasn't caught prior to accepting takeoff migration.

Currently, if there's a hyperlink or overlay the icon on the Pages panel changes. Can this icon only change when a takeoff or annotation exi...

Instinctively I'm hitting 'm', but that that is mapped to magnifier. I'm not sure about anyone else, but I use the move command way more than magn...

Sometimes I'm trying to double up on the area.

It seems the auto scale upon project upload feature was striped recently. I found it really useful and time saving. Can we have an option to selec...

I like how when a revision drawing set is added to a project zzTO stacks drawings and leaves the old set viewable. Can we have an option to view b...

I would like to be able to use the sloped linear with the same wall height/depth & width parameters as a flat linear.

I like to mark off key notes as I reviewed drawings. I know a current work around is creating a dummy takeoff, but I think this would be a useful ...

Above is not sorted in a way one would logically think they should be (i.e. 1/8" < 1/2" < 3/4" < 1-1/16" < 1-1/8" etc.)