Round Up Options for Measured Values

Hi Team,

I believe this was discussed previously, but I haven’t seen any replies yet.

Would it be possible to have the measured parent values (Area, Linear, and Segment) offer options to round, round up, and round down?

This functionality would greatly help.

Thank you for looking into this.

TJ 34d 11h

I agree with this, some of my materials have waste factors dependent upon the depth or length of the foundation.

For example, my sonotubes come in 12' lengths, usually it calls for a 4' foundation which would equal out. But in some cases I need 5' foundations,

if there is a formula that will account for this, I haven't figured it out yet.

Example- 12 point count (Pipe bollards) with 5' foundations (12" sonotubes that come in 12' lengths)

You must be logged in to post replies. If you don't have an account you can signup here.